Friday, 8 July 2011

How To Change Your IP without any tool in seconds.

Changing your IP means to change Your Complete Identity On The Internet.

How To Do It?
Steps
1). Click on "Start" in the bottom left hand corner of screen
2). Click on "Run"

3). Type in "command" and hit ok.


You should now be at an MSDOS prompt screen.


4). Type "ipconfig /release" just like that, and hit "enter" key
5). Type "exit" and leave the prompt
6). Right-click on "Network Places" or "My Network Places" on your desktop.
7). Click over "properties"


You should now be on a screen with something titled "Local Area Connection", or something close to that (depending on your os), and, if you have a network hooked up, all of your other networks.


8). Right click on "Local Area Connection" and click "properties"
9). Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab
10). Click on "Use the following IP address" under the "General" tab
11). Create an IP address (It doesn't matter what it is. I just type 1 and 2 and 3 until it fills the area up).
12). Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers (255.255.255.0).
13). Click the "Ok" button here
14). Click the "Ok" button again


You should now be back to "Local Area Connection" screen.


15). Right-click back on "Local Area Connection" and go to properties again.
16). Go back to the "TCP/IP" settings
17). This time, select "Obtain an IP address automatically"
18). Hit "Ok"
19). Hit "Ok" again
20). You now have a new IP address